ARTEMIDE architectural 2019

For further information on Ciclope visit artemide.com Ciclope Alessandro Pedretti (Studio Rota & Partners) 2009 Lighting system with diffuse unilateral or bilateral emission, with high-performance LED light sources. Light emission is obtained by the combination of six monochromatic LED light sources, a reflector and an opaline diffuser. Floor in unilateral and bilateral emission, wall or recessed installation. Available in 3 finishes: light grey (RAL 9002), anthracite grey and rust painted. Technical features of light fixtures in compliance with EN60598-1. ENEC approved. Lighting unit consists of: frame in reinforced polymer; diffuser in light-diffusing polycarbonate; plate in pickled, machined and galvanised steel; watertight gasket in silicone rubber; LED circuit; electronic ballast; reflector in painted spun aluminium; PG13.5 cable gland, H05RN-F cable and IP65 electrical connection device suitable for cables with a diameter between 6 and 13 mm to allow electrical interfacing with the external mains without the need to open the fixture. The lighting unit houses the electrical components and sources. Aesthetic cover in die-cast EN AB-47100 aluminium. The components in die-cast, extruded aluminium and steel are painted by means of 3-stage outdoor treatment: nanotechnologies, antioxidant primer, polyester paint. The elements are fixed together by means of screws. All the locking screws used outside the fixture and inside the stem are in AISI 304 stainless steel. Ciclope floor: available in two heights (h 50cm and h 90cm), stem in extruded EN AW-6060 aluminium. Ground mounting plate in folded, welded and painted steel, with holes for ground fixing by means of log bolts or dowels. Ciclope recessed: recessing box in reinforced polymer, can be ordered separately. Ciclope wall: box in extruded EN AW-6060 aluminium. 754 755