ARTEMIDE architectural 2019

For further information on Cuneo and Cuneo Mini visit artemide.com Cuneo Cuneo Mini Klaus Begasse 2010, 2015 Light fixture with direct side emission, with high-performance LED light sources. Monochromatic LEDs are used together with collimators and a light- diffusing prismatic screen to obtain an optimum lighting beam. Floor or wall installation. In the wall installation, the light can be pointed either upwards or downwards. Available in 3 finishes: light grey, dark grey and rust painted. Consists of lighting cap and terminal board fixed together by means of locking screws. Cap and terminal board in die-cast EN AB-47100 aluminium, gaskets in silicone rubber. Electronic ballast integrated in the fixture. Cuneo: PMMA collimators installed on the LED light sources. Light-diffusing prismatic screen in PMMA siliconed flush with the lighting cap. The elliptical light emission and the flat shape of the fixture make it particularly suitable for floors or spacious areas in gardens to provide a side lighting. Cuneo Mini: High-yield COB LED source with high-reflection anodized aluminium body. Etched tempered glass screen glued flush to the lighting body with silicon. Power connection to the mains to be carried out outside the fixture, without the need to open, by means of a pre-installed IP65 connection device suitable for cables with a diameter between 6 and 13 mm. Wall installation by means of a bracket in folded steel sheet to which the fixture is fastened with two screws. Screws in AISI 316 stainless steel. All the components in die-cast aluminium and the steel bracket for wall or floor fixing are painted by means of 3-stage outdoor treatment: nanotechnologies, antioxidant primer, polyester paint. Technical features of light fixtures in compliance with EN60598-1. ENEC approved. 736 737