ARTEMIDE architectural 2019

Controller Slave #1 LoT LoT cable Slave #32 max Terminator Controller Splitter Slave LoT #1 LoT Slave LoT #1 LoT Slave LoT #1 LoT Slave LoT #1 LoT Slave #32 max Slave #32 max Slave #32 max Slave #32 max cable cable cable Terminator cable cable cable Terminator cable cable cable Terminator cable cable cable Terminator cable cable cable OUT OUT IN OUT OUT OUT OUT IN OUT IN OUT OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN Controller Slave #1 LoT LoT cable Slave #32 max Terminator Controller Splitter Slave LoT #1 LoT Slave LoT #1 LoT Slave LoT #1 LoT Slave #32 max Slave #32 max Slave #32 max cable cable cable Terminator cable cable cable Terminator cable cable cable Terminator cable cable cable OUT OUT IN OUT OUT OUT OUT IN OUT IN OUT OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN LoT DMX The LoT is an DMX RDM enabled device. DMX stands for Digital Multiplex. It is simply a standard system of controlling lighting equipment and accessories. The Remote Device Management or RDM is a protocol enhancement to USITT DMX512 and enables the bi-directional communication between a lighting controller and the connected RDM devices over a standard DMX line, for simple, convenient commissioning. The protocol allows the configuration (setting of the start address, patching, load personalities), status monitoring, firmware update and management of these devices. The wiring infrastructure for DMX has been precisely defined and all installers must follow these rules. Pls refer to the Artemide DMX Brochure for detailed information. The LoT fixtures can be controlled with Standard DMX controllers (not RDM enabled) as the DSC30 NL19030 or the DSC60 NL19081.The setup of the parameters has to be carried out with a RDM controller during or before the installation. For smaller installations with small quantities, Artemide offers the possibility for a pre-setup (addressing,…) of the DMX RDM fixtures. Artemide offers the on-site support for the RDM setup and the programming of the system. Refer to the technical department of Artemide SpA for further information or assistance. At the beginning of every DMX line there must be a single DMX controller / transmitter. This can have a max. of 32 standard devices connected over a max. cable length of 300m in a multi-drop bus topology commonly called a “daisy chain”. The last DMX512 Output needs to be terminated with a 120 ohms resistor joining pins + and -. If more devices are required then a DMX splitter should be used. The output of a DMX splitter is considered a new DMX line, with the same rules applying. At the end of each DMX line a terminator should be fitted. DMX fixtures are linked by ‘daisy-chaining’ cables; Y-Splits are not possible. Pls. use RDM enabled DMX splitter for RDM light fixtures. CONFIGURATION FOR UP TO 32 LOT CONFIGURATION FOR HANDLING MORE THAN 32 LOT 100 101